There is a good probability that you have been in a situation when your car’s battery died, leaving you stranded in the middle of the road while waiting for assistance. Now, because your previous experience was unpleasant, you do not wish to repeat it. This is the reason why you must learn how to jump-start a car battery. Yes, you are in the proper place today if you wish to learn how to start an automobile by yourself. Today, PitStopArabia will outline the methods necessary to jump-start a vehicle, along with the necessary tools. Therefore, jot down these instructions, as they may come in helpful the next time your car’s battery dies.
THE RIGHT JUMPER CABLES
To jump-start a car, you do not need many tools; in fact, you only need some high-quality jumper cables. Do not be concerned because jumper cables are inexpensive and widely available everywhere. The most recommended gauge size for jumper cables is six. The reason is that it is the typical size for jumper cables. People typically believe they must purchase longer jumper cables for greater convenience, however the longer the connection, the less durable it will be because the energy must go farther. In short, when purchasing jumper cables, choose the usual size and the rest will be OK.
STEPS YOU NEED TO FOLLOW
To jump-start a car’s battery, the following steps must be meticulously followed:
Step 1
To jump-start your vehicle’s battery, you’ll need a functioning vehicle, and you’ll need to park both vehicles side-by-side. Ensure that your vehicle and the operational vehicle of the other driver are front-to-front. Separate them by 18 inches. Also, ensure that the parking brakes are engaged to prevent an accident if the vehicle moves abruptly.
Step 2:
Prevent the clamps of the jumper cables from touching. Additionally, turn off the vehicle totally. Additionally, remove the keys for safety.
Step 3
The batteries and battery terminals can be found by opening the hoods of both vehicles. Positive and negative battery terminals are indicated by black and red coverings on the battery terminals. Now, be sure to distinguish between the negative and the positive on the battery connector of the car. In the event that the terminals are dirty, wash the dirt off before continuing with the process.
Step 4
The positive cable clamp (the red one) should now be connected to the positive battery connector of the vehicle that has a dead battery. Connect the red positive battery terminal of the operating car with the other positive clamp.
Step 5
Now grab the black companion clamp and secure it to the negative terminal of the battery in the operational vehicle.
Step 6
Instead of connecting the other black clamp to the negative terminal of the dead car battery, you should use it to fasten the vehicle’s unpainted metal component. For instance, you may fasten the clamp to a clean engine nut. You can safely jump-start your car in this manner.
Step 7
Start the working vehicle now, and let it run for a bit (like a minute or two).
Step 8
Start the dead car now, and it will start straight up.
Step 9
Rev the engine of the working vehicle if the car won’t start. It’s likely to offer the dead battery the much-needed jolt.
Step 10
Remove every clamp when your car has started, making sure none of them touch. After securely removing them, go for a quick drive to allow your car to recharge.
Andrew Parker